Optional Components
There are several additional components available to compliment the standard range of Edge-Protection fittings. These additional fittings are available for all three Edge-Protection systems.
Sleeve joint [RC00]
Sleeve joint [RC00] The sleeve joint is designed to provide an in-line joint between two tubes of the same diameter.
90 Deg elbow [RC02
The 90 Deg elbow is designed to provide a joint between two tubes of the same diameter at 90 deg.
Swivel Base [RC46]
The Swivel base combination is designed to provide an angled wall or floor mounting. This fitting should not be used as a railing base without suitable support.
Grub screw M10 [GSM10]
Grub screw suitable for all fittings M10 x 12 mm.
Long tee [RC04]
The Long Tee is designed to provide a butt joint between two tubes at right angles to each other. Often used for railing ends and tops. It allows the through tube to be joined inside the fitting..
Variable elbow [BC53]
The Type 53-8 fitting has been designed as a variable angle in-line connection, adjustable through 202°.
Clamp on tee [RC41]
The Clamp on tee is designed to allow new tubes to be connected to an existing structure.
Flexible corner [RC36F]
The female flexible corner is designed as part of the swivel combination of fittings. It can be used with the RC36, RC37, RC38, or RC39 male swivel fittings.
Flexible corner [RC36M]
The male flexible corner is designed as part of the swivel combination of fittings. It can be used with the RC36F female swivel fittings
